Wrecker Operation: 1, disengage the winch clutch, pull the rope to be in front of the vehicle carrying the "j" hook hooked line is the lower end of the carriage towed vehicle towing shackle. Then winch clutch engagement. Note that when you pull the rope rope remaining laps of not less than five laps. 2, was carrying vehicle in neutral, release the cargo vehicle parking brake. 3, the control lever winch to pull the car platform and control j-hook winch cable distance is greater than 0.4m. When the winch under load, not the manual winch control clutch is disengaged, it will damage the winch. Note: When using the chain car accident towing winch hook use, especially compared with the end of the car chassis, be very careful not to damage the site has been a trailer, in order to avoid unnecessary trouble. 4. When the vehicle is loaded trailer in place, with security straps tied after tires, loaded the car back on both sides of the diagonal tension on both sides of the plate fixed on the pull ring. Note: If the Security tab is broken, safety straps should be wrapped around the car parts firm. You can not manually lock for security bandage can manipulate public winch winch close embrace joystick loader to move forward a little so that appropriate safety chain tensioner. 5, flat type wrecker, car breakdown with straps fixed on the plate, four straps must be locked in a wheel or the body. 6, must be in the closed state locking ratchet straps. Note: The long nylon straps taut appear loose, the operation should regularly check the bandage tight situation, especially in poor road conditions or braking more cases, should be checked tightened to avoid accidents. 7, tilt the joystick control platform that rises from the ground tail platform 0.15m. 8, the control platform tilt the joystick to move forward to make the platform from about 0.6m at the forefront, the joystick control platform enables the platform back to a horizontal position. 9, slip joystick control platform is a platform to move forward to the front. 10, in order to prevent the next process of moving, due to destruction of the vibration, the cable may cause tension on the winch, the car must be fixed to the front end of the preceding methods, and as far as possible with the other two tensioning safety chain. Loading position and taut. 11, will be linked to a file to load the car, pull the handbrake. 12, check all safety chain or chain belt and the connection is solid and tight. 13, after the above steps are completed, and that follow-up work program. Depress the clutch wrecker, disengage PTO, platform loading operation is complete.